GE 涡轮和励磁控制 DS200SLCCG1AEE 局域网通信板

GE 涡轮和励磁控制 DS200SLCCG1AEE 局域网通信板

DS200SLCCG1AEE：当ACS800-07的供电单元正在运行时，斩波器的启用输入端子块处于中间电路电位。该电压极其危险，如果热敏断路器的隔离水平和保护条件不够，可能会造成严重的损坏或伤害。常闭断路器应始终适当隔离（超过2.5 kV)，并避免接触。

对于启用输入接线，使用以下额定电缆：i双绞线（推荐屏蔽型）i铁芯和接地之间的额定工作电压（U0）：≥750 V i绝缘试验电压> 2.5 kV

DS200SLCCG1AEE：在驱动器应用程序中，必须禁用驱动器的过电压控制，才能正确操作制动斩波器。这已经在工厂为单位与制动直升机。

DS200SLCCG1AEE: When the ACS800-07 power supply unit is running, the chopper enable input terminal block is at the intermediate circuit potential. This voltage is extremely dangerous and may cause serious damage or injury if the isolation level and protection conditions of the thermal circuit breaker are insufficient. Normally closed circuit breakers should always be properly isolated (over 2.5 kV) and avoided contact.

To enable input wiring, use the following rated cables: i Twisted pair cable (shielded type recommended) i Rated operating voltage (U0) between the core and ground: ≥750 V i insulation test voltage > 2.5 kV

DS200SLCCG1AEE: In the driver application, overvoltage control of the driver must be disabled in order to properly operate the brake chopper. This has been in the factory for the unit with the brake helicopter.