GE DS3800NHVD1E1E 输入输出模块 燃机卡 西安

GE DS3800NHVD1E1E 输入输出模块 燃机卡 西安

产品描述

该DS3800NHVD1E1E是GE为Mark IV系列开发的PCB，旨在用作高压卡。Mark IV 是为蒸汽/燃气轮机管理而设计的。它可以自动执行一些过程以实现一致的管理，包括关闭。该系列还可用于监测水、空气和燃料排放。

椭圆形切口已从DS3800NHVD1E1E的上半部分铣出。切口的位置使其长边彼此平行并平行于短板侧。DS3800NHVD1E1E在其上边缘标记为 A-L 以进行对齐。它在工厂分八对钻孔，每个角落和长板边缘一次。

DS3800NHVD1E1E上的组件包括两个连接器点、三个变压器 （218A4499 P2 C1）、三个 LED、三个 4 针接头和一个多针垂直连接器。

该DS3800NHVD1E1E由不同值的各种电阻器构成，但作为高压卡，它更喜欢碳复合电阻器（CCR）。 此类别包括六个黑色CGN-33 52 Ω 5%20W Ni 1350W电阻器。它们位于电路板的底部边缘，与六个 Sprague（油中纸）196P 104910 电容器一致。Sprague电容器使用螺钉安装的夹具连接到电路板。电路板上也使用较小的电容器。

该DS3800NHVD1E1E包含从PTH到PTH的表面布线。三根黑线和三根白线连接带有标签的 PTH。

GE DS3800NHVD1E1E 输入输出模块 燃机卡 西安

Product description

The DS3800NHVD1E1E is a PCB developed by GE for the Mark IV series and is designed to be used as a high voltage card. The Mark IV is designed for steam/gas turbine management. It can automate some processes for consistent management, including shutdown. The series can also be used to monitor water, air and fuel emissions.

The oval cut has been milled from the upper half of the DS3800NHVD1E1E. The notches are positioned so that their long sides are parallel to each other and parallel to the side of the short plate. DS3800NHVD1E1E has its upper edge labeled A-L for alignment. It is drilled in eight pairs at the plant, once at each corner and at the edge of the longboard.

The components on the DS3800NHVD1E1E include two connector points, three transformers (218A4499 P2C1), three leds, three 4-pin connectors, and a multi-pin vertical connector.

The DS3800NHVD1E1E is made up of various resistors with different values, but as a high voltage card, it prefers carbon composite resistors (CCRS). This category includes six black CGN-33 52 Ω 5%20W Ni 1350W resistors. They are located on the bottom edge of the board, in line with six Sprague (paper in oil) 196P 104910 capacitors. Sprague capacitors are attached to the circuit board using screws mounted clamps. Smaller capacitors are also used on circuit boards.

The DS3800NHVD1E1E contains surface wiring from PTH to PTH. Three black and three white wires connect the labeled PTH.