GE DS3800NGTC1B1C 涡轮控制组件板 有8个蓝色电位器 安康

GE DS3800NGTC1B1C 涡轮控制组件板 有8个蓝色电位器 安康

产品描述

DS3800NGTC1B1C是GE为其Mark IV（Speedtronic）系统制造的PCB。该系统是为燃气轮机/蒸汽轮机管理而开发的，采用集成芯片组构建，设计有三分之二的投票冗余，适用于所有保护参数和关键控制。这可以zui大限度地减少由电子故障引起的停机时间。Mark IV可用于自动化某些程序，例如启动和关闭，还可以监测空气，水和燃料排放。

DS3800NGTC1B1C已使用以下规格和组件构建：

它在每个角落都是双重钻孔。它还在每个长板侧的两个位置都有成对的钻孔。

它有三个从棋盘中间切下来的大椭圆形

它被标记对齐。

它有三个连接到顶部边缘的 4 针接头。

它有一个垂直（公）多针接头。

它有三个变压器。这些标记为 218A4499 P2 C1。

它有三个发光二极管（LED）。

它由多个CCR（碳复合材料）电阻器以及一些金属膜电阻器构成。CCR 电阻器包括 CGN-33 52 Ω 5% 20W Ni 1350W。这些是带有轴向端子的绕线电阻器。

它有几种不同类型的电容器，包括 Sprague 纸油 196P104910 和 Wesco 33mm 10% 2.0 8110 100 V。Sprague电容器通过螺钉安装的夹具固定在电路板上。

GE DS3800NGTC1B1C 涡轮控制组件板 有8个蓝色电位器 安康

Product description

The DS3800NGTC1B1C is a PCB manufactured by GE for its Mark IV (Speedtronic) system. The system was developed for gas turbine/steam turbine management, built with an integrated chipset and designed with two-thirds voting redundancy for all protection parameters and critical controls. This minimizes downtime caused by electronic failures. The Mark IV can be used to automate certain procedures, such as start-up and shutdown, and can also monitor air, water and fuel emissions.

The DS3800NGTC1B1C has been built with the following specifications and components:

It's double drilled at every corner. It also has pairs of boreholes at two locations on each longboard side.

It has three large ovals cut out of the middle of the board

It is labeled aligned.

It has three 4-pin joints attached to the top edge.

It has a vertical (male) multi-pin joint.

It has three transformers. These are labeled 218A4499 P2 C1.

It has three light-emitting diodes (leds).

It consists of multiple CCR (carbon composite) resistors and some metal film resistors. CCR resistors include CGN-33 52 Ω 5% 20W Ni 1350W. These are wound resistors with axial terminals.

It has several different types of capacitors, including Sprague Paper Oil 196P104910 and Wesco 33mm 10% 2.0 8110 100 V. Sprague capacitors are secured to the circuit board by screws mounted clamps.