GE DS3800NGTA1E1D 驱动器 模拟 I/O 板 合肥

GE DS3800NGTA1E1D 驱动器 模拟 I/O 板 合肥

产品描述

DS3800NGTA1E1D是由GE制造的PCB，适合其Mark IV（Speedtronic）系列。Mark IV是为燃气轮机和蒸汽轮机控制而创建的，它依赖于故意冗余的集成芯片组，以zui大限度地减少市中心。Mark IV可以自动执行某些过程，包括启动和关闭，以实现更一致的涡轮机系统管理。

对齐标记已添加到DS3800NGTA1E1D的一个边。代码“6DA03”和“6BA04”已放置在相反的边缘。该板经过钻孔以进行安装。四个尼龙销插入电路板的右象限。它们支持可选的辅助板。这些引脚附近是板上的两个通信连接器之一。这是一个多针公头垂直连接器。另一个连接器是位于左边缘的母连接器。后一个连接器标记为 218A4553-1Amp。

DS3800NGTA1E1D的每个右上角都安装了一个提取器夹。这些夹子旨在帮助技术人员从狭窄的位置安装和取出电路板。它们可以根据需要用作手柄，从而保护精密电路。它们还可以利用杠杆作用，将电路板推到位。

DS3800NGTA1E1D具有三个微调电位计和三个电阻网络阵列。网络阵列可用于分压。它有五个TP测试点和四个LED。该板有一个拨动开关。该板由二十五个集成电路和各种电容器、电阻器（主要是陶瓷覆盖的金属膜）和二极管组成。

GE DS3800NGTA1E1D 驱动器 模拟 I/O 板 合肥

Product description

The DS3800NGTA1E1D is a PCB manufactured by GE for its Mark IV (Speedtronic) series. Created for gas and steam turbine control, the Mark IV relies on intentionally redundant integrated chipsets to minimize downtown. The Mark IV can automate certain processes, including start-up and shutdown, for more consistent turbine system management.

The alignment mark has been added to an edge of the DS3800NGTA1E1D. The codes "6DA03" and "6BA04" have been placed on the opposite edge. The board is drilled for installation. Four nylon pins are inserted into the right quadrant of the board. They support optional auxiliary boards. Near these pins is one of the two communication connectors on the board. This is a multi-pin male vertical connector. The other connector is the female connector located on the left edge. The latter connector is labeled 218A4553-1Amp.

Each upper right corner of the DS3800NGTA1E1D is fitted with an extractor clip. These clamps are designed to help technicians install and remove circuit boards from narrow locations. They can be used as handles as needed, thus protecting precision circuits. They can also use leverage to push the board into place.

The DS3800NGTA1E1D has three trimmer potentiometers and three resistor network arrays. Network arrays can be used for voltage separation. It has five TP test points and four leds. The board has a toggle switch. The board consists of twenty-five integrated circuits and a variety of capacitors, resistors (mainly ceramic covered metal films) and diodes.