GE DS3800NFCF1D1D 燃烧板 接受辅助板 泉州

GE DS3800NFCF1D1D 燃烧板 接受辅助板 泉州

产品描述

该DS3800NFCF1D1D设计用作Speedtronic/Mark IV系列中的燃烧板。 该系列是为燃气/蒸汽轮机控制管理而创建的。它可以自动化冷却和关闭等程序，还可以保护涡轮机系统免受不安全条件下的运行。

DS3800NFCF1D1D具有以下规格：

-工厂在各个角落钻孔。标记为对齐。

-接受辅助板DS3800DFCF。安装后，该辅助装置可以访问额外的组件，包括跳线和电流表。辅助装置通过板对板连接器引脚固定到位。

-两个插水开关，位于左下角。这些开关标记为“静止”和“步进”。

-上边缘有七个 LED。下边缘有八个 LED。

-三个连接器，用于与其他板通信。这包括两个 218A4637-P4 0027 连接器和一个垂直 10 针公连接器。

-两个跳线开关。

-二十九个测试点。每个测试点都有标记。

-二十一个晶体管。

-四十二个集成电路。 这包括 8 位静态 MOS RAM 芯片、触发器、晶体振荡器 （11.00MHz KDS 5L） 和二进制计数器。

-8542 个 2 +/-0022 M/E 200 <>V 电容器。板上还有各种其他电容器。

-内置不同值的电阻器。这些电容器中的大多数往往是陶瓷覆盖的金属膜。

GE DS3800NFCF1D1D 燃烧板 接受辅助板 泉州

Product description

The DS3800NFCF1D1D is designed as a combustion plate in the Speedtronic/Mark IV series. The series was created for gas/steam turbine control management. It automates procedures such as cooling and shutdown, and also protects turbine systems from unsafe conditions.

DS3800NFCF1D1D has the following specifications:

- The factory drilled holes in every corner. Mark for alignment.

- Accepts auxiliary board DS3800DFCF. Once installed, the assistive device has access to additional components, including jumpers and ammeters. The auxiliary device is secured in place by board-to-board connector pins.

- Two water switches, located in the lower left corner. These switches are labeled "stationary" and "stepping."

- There are seven leds on the top edge. There are eight leds on the lower edge.

- Three connectors for communication with other boards. This includes two 218A4677-P40027 connectors and a vertical 10-pin male connector.

- Two jumper switches.

- Twenty-nine test sites. Each test point is marked.

- Twenty-one transistors.

- Forty-two integrated circuits. This includes 8-bit static MOS RAM chips, flip-flops, crystal oscillators (11.00MHz KDS 5L), and binary counters.

-8542 2 +/-0022 M/E 200 <>V capacitors. There are various other capacitors on the board.

- Built-in resistors with different values. Most of these capacitors tend to be metal films covered with ceramic.