1771-OX 是一款电源触点输出模块 有四个状态指示器
艾伦-布拉德利 1771-OX 是一款电源触点输出模块。该模块有 4 个常开/常闭输出点可用。该模块有四个状态指示器,每个输出 1 个指示器。这些指示器表示输出继电器线圈通电或断电的状态。1771-OX 还具有一个保险丝,可作为过载情况的保护。如果过载,输出电路将被打开。
1771-OX 模块的额定电压为 0-250V AC RMS 和 0-175V DC。它的zui大额定电流为 2 A,额定功率为 200 VA。该模块存在浪涌电流,这些电流是 5.5A AC 峰值持续 5 秒、6A DC 持续 500 秒和 15A DC 持续 500 毫秒。请注意,浪涌电流每 10 秒可重复一次。该模块的zui大导通状态接触电阻为0.25 Ω,zui大背板电流为550 mA,隔离电压为2500V AC RMS。
其功耗范围为zui小 10.2 W 至zui大 6.2 W。该模块的散热范围从zui小 9.8 BTU/小时到zui大 9.9 BTU/小时不等。
1771-OX 是一款电源触点输出模块 有四个状态指示器
The Allen-Bradley 1771-OX is a power contact output module. The module has 4 normally open/normally closed output points available. The module has four status indicators, each output 1 indicator. These indicators indicate whether the output relay coil is powered on or off. The 1771-OX also has a fuse that acts as protection in case of overload. If overloaded, the output circuit will be turned on.
The 1771-OX module is rated for 0-250V AC RMS and 0-175V DC. It has A maximum rated current of 2 A and a rated power of 200 VA. The module has surge currents, which are 5.5A AC peaks lasting 5 seconds, 6A DC peaks lasting 500 seconds, and 15A DC peaks lasting 500 milliseconds. Please note that the surge current can be repeated every 10 seconds. The module has a maximum on-state contact resistance of 0.25Ω, a maximum backplane current of 550 mA, and an isolation voltage of 2500V AC RMS.
Power consumption ranges from a minimum of 10.2W to a maximum of 6.2W. The module's heat dissipation ranges from a minimum of 9.8 BTU/ hour to a maximum of 9.9 BTU/ hour.
1771-OX 是一款电源触点输出模块 有四个状态指示器
型号推荐
3604E 康吉森 Triconex DCS 数字输出模块
3636R 康吉森 Triconex DCS 通信模块
3501E 康吉森 Triconex DCS 输入数字模块组件
3601E 康吉森 Triconex DCS 数字输出模块
3805H 康吉森 Triconex DCS 数字输入模块
9668-110 康吉森 Triconex DCS 控制板终止
3502E 康吉森 Triconex DCS 通信模块
4101 康吉森 Triconex DCS 通信模块
4107 康吉森 Triconex DCS 通信模块
4118 康吉森 Triconex DCS 通信模块
4119 康吉森 Triconex DCS 通信模块
4119A 康吉森 Triconex DCS 通信模块
2551 康吉森 Triconex DCS 二酯型终止子
4000163-510 康吉森 Triconex DCS 模拟输出模块