GE DS3800HSQD1F1D 使用 4 个螺钉来固定板

GE DS3800HSQD1F1D 使用 4 个螺钉来固定板

GE 低 HP 序列板DS3800HSQD1F1D设计为每个角上都有一个孔，用于插入螺钉以将板固定在驱动器中。GE 低 HP 序列板DS1HSQD3800F1D还配备了 1 个 2 针连接器和 40 个带固定杆的 1 针连接器，用于固定带状电缆。该板还装有 20 针连接器和 50 个 1 针连接器。该板还装有 20 个可擦除可编程只读存储器 （EPROM） 模块和 1 个琥珀色指示灯 LED 和 1 个红色指示灯 LED。

安装更换的 GE 低 HP 序列板DS3800HSQD1F1D需要使用 4 个螺钉来固定板。从驱动器中卸下有缺陷的板时，将 4 个螺钉聚集在一起并存放在安全的地方。使用螺钉固定更换板。注意不要将它们放入驱动器中。如果碰巧螺丝掉入驱动器，请停止更换程序并找到螺丝。如果它落在电路板或其他电气连接上，可能会导致短路。短路会导致电气火灾。火灾可能导致设备损坏或操作员或周围区域的其他人受伤。如果它掉入电机或其他运动部件，可能会导致堵塞，损坏运动部件。取回螺钉后，您可以继续更换任务。

使用螺丝刀用螺钉固定电路板。但是，不要过度拧紧螺钉。

GE DS3800HSQD1F1D 使用 4 个螺钉来固定板
The GE Low HP sequence board DS3800HSQD1F1D is designed with a hole in each corner for inserting screws to secure the board in the drive. The GE low HP sequence board DS1HSQD3800F1D also comes with 1 2-pin connector and 40 1-pin connectors with fixed rods for securing ribbon cables. The board is also equipped with 20-pin connectors and 50 1-pin connectors. The board is also equipped with 20 erasable programmable read-only memory (EPROM) modules and one amber LED and one red LED.

Installing the replacement GE low HP serial board DS3800HSQD1F1D requires the use of four screws to secure the board. When removing the defective board from the drive, gather the 4 screws together and store them in a safe place. Use screws to secure the replacement plate. Be careful not to put them in the drive. If a screw happens to fall into the drive, stop the replacement process and locate the screw. If it lands on a circuit board or other electrical connection, it could cause a short circuit. Short circuits can cause electrical fires. A fire may result in damage to the equipment or injury to the operator or others in the surrounding area. If it falls into the motor or other moving parts, it may cause blockage and damage the moving parts. After retrieving the screws, you can continue with the replacement task.

Fasten the circuit board with screws using a screwdriver. However, do not over-tighten the screws.

GE DS3800HSQD1F1D 使用 4 个螺钉来固定板

型号推荐
4119 康吉森    Triconex DCS    通信模块
4119A 康吉森    Triconex DCS    通信模块
2551 康吉森    Triconex DCS    二酯型终止子
4000163-510 康吉森    Triconex DCS    模拟输出模块
4328 康吉森    Triconex DCS    网络通信模块
4329 康吉森    Triconex DCS    网络通信模块
4400 康吉森    Triconex DCS    网络通信模块
4500 康吉森    Triconex DCS    公路接口模块
4507 康吉森    Triconex DCS    公路接口模块
4609 康吉森    Triconex DCS    通信模块
4211 康吉森    Triconex DCS    通信模块
9566-810 康吉森    Triconex DCS    容错电路板
9566-8XX 康吉森    Triconex DCS    容错电路板