IS220PAICH1A   GE IO控制包涡轮机控制

IS220PAICH1A  GE IO控制包涡轮机控制

IS220PAICH1A型号被描述为模拟I/O包，已被批准用于危险和非危险场所。在模型的正面，有四个指标。底部还有一个端口，它被描述为I/O端口。有几种电压可以与PAIC包一起使用，PAIC包的zui小电压是27.4伏的直流电。

由于IS220PAICH1A包能够在许多地方使用，因此有各种与IS220PAICH1A包相关的认证，其中一些是危险场所，一类区域二组IIC，一类区域二组a, B, C, D和ATEX区域二，IIC组和非危险场所也是如此。以下认证用于地点，UL E207685和UL DEMKO 12 ATEX 1114875X，请注意UL E207685认证用于许多地点。

有三种型号可以与IS220PAICH1A单元一起使用，即IS200STAIH1A和IS200STAIH2A以及IS20TBAIH1C型号。所有这些型号都被称为输入输出端子板。

IS220PAICH1A  GE IO控制包涡轮机控制

The IS220PAICH1A model is described as an analog I/O package that has been approved for use in hazardous and non-hazardous locations. On the front side of the model, there are four indicators. There is also a port on the bottom, which is described as an I/O port. There are several voltages that can be used with the PAIC package, the minimum voltage of the PAIC package is 27.4 volts of direct current.

Since the IS220PAICH1A package is capable of being used in many places, there are various certifications associated with the IS220PAICH1A package, some of which are hazardous places, Zone 1 Group 2 Iics, Zone 1 Group 2 a, B, C, D and ATEX Zone 2, IIC Group and non-hazardous places as well. The following certifications are used for locations, UL E207685 and UL DEMKO 12 ATEX 1114875X, please note that UL E207685 certifications are used for many locations.

There are three models that can be used with the IS220PAICH1A unit, namely the IS200STAIH1A and IS200STAIH2A and the IS20TBAIH1C model. All of these models are referred to as input/output terminals.
IS220PAICH1A  GE IO控制包涡轮机控制