BENTELY 135489-01 瞬态数据接口模块

BENTELY 135489-01 瞬态数据接口模块

3500/42M监控器的主要用途是:
1.通过连续比较监测参数进行机械保护根据配置的告警设定值来驱动告警。
⒉机器操作和维护的基本信息人员。每个通道，取决于配置，通常将其输入信号设置为生成各种称为“静态值”的参数。用户可以配置告警的任意两个活动静态值的设定值和危险设定值活动静态值。

下图显示了为REBAM配置的监视器通道对所允许的zui大机器速度。上图假设通道对的两个通道都已启用。
下图假设只有一个通道启用通道对的。zui大转速取决于轴承中滚动元件的数量。的图中假设转子低通滤波器角设置为轴转速的3.2倍，尖峰高通滤波器角为设置为4倍的元素通过频率的外部种族(BPFO)。

BENTELY 135489-01 瞬态数据接口模块

The main uses of the 3500/42M monitor are:
1. Perform mechanical protection by continuously comparing monitoring parameters to drive alarms based on the configured alarm Settings.
B. Basic information personnel of machine operation and maintenance. Each channel, depending on the configuration, typically sets its input signal to generate various parameters called "static values." The user can configure the setting value of any two active static values of the alarm and the danger setting The active static value.

The following figure shows the maximum machine speed allowed for the monitor channel pair configured for REBAM. The figure above assumes that both channels of the channel pair are enabled.
The following figure assumes that only one channel has a channel pair enabled. The maximum speed depends on the number of rolling elements in the bearing. The diagram assumes that the rotor low-pass filter Angle is set to 3.2 times the shaft speed and the spiking high-pass filter Angle is set to 4 times the element passing frequency of the external race (BPFO).

BENTELY 135489-01 瞬态数据接口模块