IS230TNCIH4C 电路板 共有25个金属氧化物压敏电阻

IS230TCISH6C 是一款通用且可靠的控制模块

产品描述
IS230TNCIH4C板由通用电气作为印刷电路板销售。该电路板可以安装在 13 或 21 个 VME 插槽式机架中。当用于单工架构类型系统时，它通常与控制模块一起使用，但如果选择的架构是三重冗余的，它将与 IONet、主处理器卡和控制模块一起使用。

TNCI模型可以使用两种主要的通信类型，即单元数据高速公路（基于以太网的LAN类型的通信）和IONet通信。请注意，UDH通信驱动程序通常与位于Mark VI系统内的主处理器卡相关联。

虽然IS230TNCIH4C板由十几个电容器、电阻器甚至更多的小元件组成，但该模型的主要视觉元件是两个接线端子、三个sub-D针连接器、两个母插头型连接器和金属氧化物压敏电阻，共有25个。两个接线端子标记为 TB1 和 TB2，位于电路板底部边缘附近，金属氧化物压敏电阻位于两个接线端子的正上方。三个sub-D引脚连接器位于电路板的顶部边缘附近，每个连接器由37个引脚组成。

IS230TNCIH4C 电路板 共有25个金属氧化物压敏电阻
Product description
The IS230TNCIH4C board is marketed by General Electric as a printed circuit board. The board can be installed in 13 or 21 VME slot type racks. When used in simplex architecture type systems, it is usually used with a control module, but if the architecture chosen is triple redundant, it will be used with IONet, the main processor card, and the control module.

TNCI models can use two main types of communication, namely cell data superhighway (Ethernet-based LAN-type communication) and IONet communication. Note that UDH communication drivers are typically associated with the main processor card located within the Mark VI system.

Although the IS230TNCIH4C board consists of more than a dozen small components of capacitors, resistors and even more, the main visual elements of the model are two terminal blocks, three sub-D pin connectors, two female plug type connectors and metal oxide varistors, for a total of 25. The two terminals, labeled TB1 and TB2, are located near the bottom edge of the board, and the metal oxide varistor is located directly above the two terminals. Three sub-D pin connectors are located near the top edge of the board, each consisting of 37 pins.

IS230TCISH6C 是一款通用且可靠的控制模块